- Listed Organic by OMRI (Organic Materials Review Institute)
- Kills Spider mites, Leaf Aphids, Whitefly and more
- Kills eggs, larvae, juvenile and adult insects
- Reduces Powdery Mildew
- Is concentrated and economical
- Is approved for use on the day of harvest
- Is safe around people and pets when used as directed
- Doesn’t alter the taste or smell of growing crops or finished produce
- Doesn’t lower the value of produce
- Doesn’t slow photosynthesis by reducing light to photon cells on leaves like oil pesticides can
- Doesn’t slow photosynthesis from residue clogging the leaf stomata like oil pesticides can
- Doesn’t contain high concentrations of oils
- Doesn’t contain chemical surfactants
- Doesn’t contain petroleum or Pyrethrin’s
- Doesn’t smell bad
- Doesn’t make leaves, stems and flowers sticky like oil pesticides can
The Organic pesticide Nuke Em® has been introduced to the indoor/outdoor gardening community by Flying Skull Plant Products. This multi-purpose Organic insecticide/fungicide is listed for Organic use by OMRI (Organic Materials Review Institute). It kills the eggs, larvae, juvenile and adult insects. Nuke Em® targets all species of Mites, Leaf Aphids, Whitefly and other plant leaf and soil insect parasites. Its unique formula also allows for outstanding control of the vast varieties of powdery mildew and mold found in the garden. Nuke Em® is different than oil-based pesticides (oil-based pesticides have oil as their active ingredient). Nuke Em® will not slow the plant's growth as oil-based pesticides can. Also, Nuke Em® will not significantly lower the light coming into leaf cells and it will not significantly obstruct air from going into and out of the leaf’s stomata as oil-based pesticides can. Nuke Em® has killing power while allowing the plant to thrive while going through treatment. Nuke Em® is the correct choice.
Is Nuke Em® registered in Washington State for I-502?
Is Nuke Em® registered and on the Official List in Florida State for commercial grows?
Nuke Em® won’t lower the value of your harvest like other insecticides/fungicides!
You’ve worked hard for your customers, don’t lose them because your harvest didn’t taste or smell the same. Think about it; do you have customers that purchased from you but then they suddenly stopped? Was it after a crop you treated with insecticides or fungicides? Did those insecticides/fungicides have Pyrethrums, concentrated plant oils, petroleum oils or detergents in them? Don’t feel alone. We have gotten thousands of new customers because they lost profit from crops after they applied supposedly natural pesticides. Don’t worry; Nuke Em® is here to keep your plant value high and your customers loyal!
Be wary of insecticides made with concentrated oils as their active ingredient because they need detergents to make them water soluble. Once dried, these ingredients will plug and cover the plant’s leaf stomata and cover the light cells that produce sugars in the photosynthesis process. This slows plant growth, reducing water uptake, and makes it harder for the plant to recover from insect attack.
This is why your plants had slow or stunted growth after you sprayed with oil and detergent-based products. How do you know if you’re using oil and detergent-based pesticides? Oil and detergent-based pesticides look like milk or chalky water when mixed with water. Their oils are mixed with detergent and water but the ready-to-use spray smells like the oils it’s made with or the smell of the detergent. These concentrated plant oils include Neem, Rosemary, Pine, Peanut, Rose and others too many to mention.
Remember: All oils, no matter what quality they are, need to have detergent added to become soluble in water. If you spray oil-based pesticides on a window and let it dry, you can write your name in the dried residue with your fingernail.
Should I add a wetting agent to Nuke Em®?
Look for our wetting agent, Spread Coat. Spread Coat is OMRI listed and made to work with Nuke Em®. It is now available.
Yes, we are finding that using a surfactant or wetting agent helps Nuke Em® to cover the leaf and in doing so contacts the insects, larvae, eggs etc. Plants leaves, some more than others, have a waxy cuticle which will tend to shed water and or the Nuke Em®. By adding the wetting agent, the leaf will get full coverage. The analogy for cars would be a freshly waxed car sheds water in beads. Add a wetting agent to the water and you have no more beads but a sheeting action over the fender.
Adding a wetting agent will allow you to use less Nuke Em® as more spray will stay on the leaf; less will be on the floor or ground.
Pro Growers Note: When ordering Nuke Em®, order Z7 at the same time. Over 80% of the time, leaf insect and powdery mildew attack indicates root zone problems! Start using Z7 now! Z7 is amazing and very inexpensive to use. It has saved countless growers from major malfunctions and made huge differences in yield and crop consistency. Z7cleans bio-film from growing medium, pipes, tubes and entire grow systems. Z7 will release mineral ions from carbon bonds so everything in the root zone remains cleansed by greatly reducing mineral build up from plastic.
I have a big infestation of broad mites, what are my options?
Because Nuke Em® is a contact killer it is very important that every mite and egg come into contact with Nuke Em®. Even in the best conditions with careful applications, it is very hard to get complete coverage on the first spray. Use Flying Skull’s wetting agent, Spread Coat, to help Nuke Em® stick to the leaf and get good coverage.
Growers are reporting to us that they have had good luck with these MODIFIED applications. Remember to wash all other insecticides and fungicides off leaves before applying Nuke Em®. Modified applications are always best done by spraying a few plants and observing before spraying them all. 95% of growers that have insect problems have soil/growing mediums that are saturated with fertilizer causing the plant to become weak. The insects now have a home on a plant that can’t put up decent self-defense. It is extremely important to wash this excess fertilizer from the growing media before the application of any brand of insecticide. If the plant can’t get water from the roots, it will take water in through the leaves. If the water sprayed on the leaves has an insecticide in it, the insecticide will be brought into the plant for use in photosynthesis and vascular relocation. You never want to feed a plant insecticide. So, make sure the plant is fully hydrated before any application of insecticide or fungicide no matter the brand or type of insecticide.
Growing media should be flushed in such a fashion that the water coming from the pot is no more than 50 PPM/TDS above the water supply’s PPM/TDS going into the pot. Only a PPM/TDS/EC meter can tell you this.
These initial flushing steps below will make sure that the plants will hydrate properly.
These steps will help the plant recover quickly from the initial insect attack and stress from insecticide applications.
Flush the plant site with Z7 treated water. Use at least twice the amount of water than what the container holds in media, but more water is always better in this instance. (This includes plants grown in hydroponics.) Wait an hour and then pour a small amount of water across the top of the soil and catch the runoff for testing. You want to see this PPM number no more than 50 PPM above the PPM of your virgin water. The use of Flying Skull’s Z7 in the water at the time of the flush, and continued use afterward, would of great benefit to the plants.
If you don’t have access to a hand-held EC/PPM meter, flush your plants very well with large amounts of water runoff three times and wait one hour before applying Nuke Em®.
After applying Nuke Em®, resume feeding your soil or soil-less grown plants. Always use the Z7 as it is a key factor in healthy plant growth.
This is the modified Nuke Em® application our customers said helped them with Broad Mite and Russet infestations. Let us know how it worked for you.
MODIFIED APPLICATION 1
DAY ONE: Apply one application at strong strength when heat producing lights are turned to a low level or if HID lights are more than 10 feet above the canopy, wait until it dries and then spray another application at strong strength, wait for the second application to dry and then spray another application at strong strength. (Three applications on the same day allowing the plants to completely dry between applications).
DAY THREE: Spray one strong strength application.
DAY SIX. Spray one strong strength application. Check for any signs of insects in the following days.
Use our wetting agent called Spread Coat to help coat leaves and stems.
Think of Nuke Em® as brakes on your car. While driving, you don’t use your brakes all the time but your brakes are a very important part of your trip. Nuke Em® should be used as a maintenance spray every week. No matter how careful you are insects and powdery mildew will enter the growing area. Large scale growers use Nuke Em® as a maintenance tool that keeps them from having problems that reduce harvest quantity or quality. Nuke Em® is a tool. It is part of the cost of doing business. It is better to bear the extra cost of maintenance than not have a good supply of quality produce when customers ask for it. Remember, customers will find produce elsewhere if you can’t supply them what they want when they want it.
Outdoor growers have reported successful maintenance programs to control Powdery Mildew by using this rate of spray weekly: 1- 2 ounces of Nuke Em® to every gallon of water with the Spread Coat wetting agent added at 5 to 10 mls (1-2 tsp) per gallon of water. See more in the FAQ section of this website. This rate will make 64 gallons of ready to use spray for every gallon of Nuke Em® concentrate.
Other insecticides, fungicides and plant washes use brain and body nerve poisons, detergents, chemical surfactants, petroleum or plant oil in their formulas that leave smelly, bad tasting and sticky residue on produce. Ultimately these ingredients will reduce the sales, desired flavor and smell of the gardener’s produce.
Anyone using Flying Skull’s Nuke Em® will immediately see a reduction of plant parasites and Powdery Mildew. At the same time, they will notice that Nuke Em® is easy to use, safer to spray, doesn’t smell bad, and did not reduce the value of the produce!
Nuke Em® is a multi-purpose product. It replaces many expensive single target pesticides and fungicides. This makes it very affordable. It can be used to kill hiding insects and mold on walls, floors and other gardening surfaces.
Nuke Em®’s highly concentrated formula must be diluted before spraying onto plants or garden surfaces. Read and follow all label cautions and directions. Nuke Em® has been in the lab for over 10 years prior to its release.
8 fl. oz. concentrate makes up to 2 gallons of ready to use spray.
32 fl. oz. concentrate makes up to 8 gallons of ready to use spray.
1 Gallon concentrate makes up to 32 gallons of ready to use spray.
Nuke Em® is not registered with the US Federal Environmental Protection Agency. Its formula qualifies for exemption under FIFRA section 25 (b).